Gas Chain Saw Gas Power Handheld Chain Saw 60cc 22 Inch Chain Saw For Wood Trees Cutting Tree Trimming Garden Farm Ranch Home

60cc Gas Powered Chainsaw Suitable for garden pruning, forest logging, chopping wood, bamboo harvesting, timber making, ice cutting, tree pruning, clearing land, preparing firewood or cleaning up, outdoor wood cutting, for home, garden, ranch, and farm use. How to Assemble the Chainsaw 1. Install the jam teeth in the right direction. 2. Install the guide bar. 3. Install the chain. 4. Cover the side cover. 5. Adjust the chain tightness. 6. Tighten the screw. How to Start the Chainsaw 1. Push the brake. 2. Move the On/Off switch to the On position. 3. Pull the choke knob fully out to position. 4. Pull the start handle(Max 6 times). 5. Push the choke knob back fully. 6. Pull the starter until the engine start. Specification Color: Orange Style: Modern Assembly Required: Yes Material: Nylon, Mn Steel, Aluminum Engine Type: Single Cylinder, Air-cooled, 2-Stroke Ignition System: Self-reset Pull Start Fuel Tank Capacity: 550ml/18.6Oz Chain Fuel Tank Capacity: 140ml/4.73Oz Bore: 45.2mm/1.78inch Volume: 116dB Power: 2.8kw Speed: 10000rpm Displacement: 60cc Oil Mixture: 25:1(90# Gasoline: Oil) Max. Cutting Diameter: 55cm/22in Chain Length: 55cm/22inch Product Size: 96*24*29cm/37.79*9.44*11.41in Package Size: 60*27*33cm/23.6*10.6*13in Gross Weight: 8kg/17.64lb Notes 1. Before starting the gasoline chainsaw, please ensure that it fits well with the guide bar, and use a wrench to adjust the chain. When installing the guide bar, please note that the screw column on the side cover must be aligned with the guide bar hole before installation(The function of the screw column is to adjust the chain tightness.). 2. Please use gasoline 90# with special 2-cycle engine oil and never use pure gasoline. Gasoline and oil mixture ratio: 25:1. The oil output can be controlled to turn larger to the left and smaller to the right. 3. Please note that after the first ignition sound, closing the choke and repeatedly pulling the start handle will suck in too much fuel and prevent the engine from starting. 4. If the choke knob is not fully pushed back after pulling the starter handle up to 6 times, the engine preheating may be missed. Too much fuel will flow out and submerge the spark plug. Then you can’t start the chainsaw. The damper is used to regulate air intake. When the engine is cold or not used for a long time, the damper needs to be pulled. If the engine is hot, it can be started directly. This is the same as the principle of starting a motorcycle! Close the damper, pull the start handle again 1-3 times to start it, and then you can use it normally. 5. Please pay attention to the tightness of the chain during installation (Pull the chain by hand. The distance between the chain and the guide plate is 0.12-0.2 inches.), otherwise, it will affect the use effect. 6. After the chainsaw is started (The oil filler door must be empty.), it must wait for the chain to receive oil before starting to work(The oil pump will discharge oil and the ground will become wet.). 7. The carburetor must be cleaned after every 100H of operation before use. The air filter must be cleaned after 8H of operation. When the chainsaw is not in use, it is better to pack it in plastic bags to avoid dust and water entering the machine and affecting its use. If the chainsaw is not used for a long time, the fuel oil in the tank must be cleaned.